Companyleader
HomeApplication areaDocumentsOur partnersAbout Us
Companyleader
Pultrusion

 

 

As a continuous and highly automated closed mold process, pultrusion is cost-effective in high volume production  runs of constant cross-section parts. The process relies on a reciprocating or caterpillar-type puller/clamping system to pull the fiber and resin continuously through a heated steel die.

Heat control is a critical part of pultrusion. For this reason, controllers are available to monitor and maintain a pre-set temperature in various zones throughout the die and mandrels. For all-roving pultrusion, a radio frequency (RF) generator can be used to accelerate cure by pre-heating the wet material package. RF energy initiates cure before the material enters the die, reducing cure time and increasing running speed. For example, the running speed for all-roving 1.3 cm rod is about 53 cm per minute. With RF pre-heating, running speed can increase to 25 cm per minute. RF is not generally recommended where mat and/or fabrics are pultruded.

CRAY VALLEY provides both resins and low profile additives for pultrusion.

 

Reference

Comment

TDS

NORSODYNE 6394

Tough isophthalic resin, for aggressive environments

PDF

NORSODYNE G 703

Isophthalic resin, for aggressive environments

PDF 

NORSODYNE H 16239

Ortho resin

PDF 

NORSODYNE M 01510

Maleic resin, good aesthetics 

PDF 

NORSODYNE M 0550 I

Maleic resin with good mechanical and aesthetic properties 

PDF 

NORSOLOOK A 70933

Low profile additive at room temperature 

PDF 

NORSOLOOK A 71074

Low shrink additive (PVAc) for white profiles with good aesthetics 

PDF 

NORSOLOOK A 76086

Low shrink additive (saturated polyester – PVAc) with excellent aesthetic properties 

PDF 

 

Title Filter     Display # 
# Article Title Author
 

Contact with us:

WE HAVE MOVED!!!!

NEW ADDRESS:

Str. Ushinskogo 40, of. 503

03151, Kiev, Ukraine

Watch on Yandex map

 

GENERAL TEL./FAX.:

+38 (044) 496-21-56

ADDITIONAL:

+38 (044) 451-73-57