Companyleader
HomeApplication areaDocumentsOur partnersAbout Us
Companyleader
Infusion process

 

    Infusion is a process used to manufacture fiber-reinforced plastic parts in which disposable films are applied over the laminate.

    Dry materials are stacked onto a male or female mold surface and a thin plastic vacuum bag or semi-rigid counter mold is sealed around the part’s perimeter. A vacuum pump is used to evacuate the air and apply atmospheric pressure to consolidate the dry materials and create a “vacuum cavity”. Resin is then introduced into the cavity via strategically placed resin feeder lines.

    The pressure differential between the cavity and the outside atmospheric pressure pushes the resin through the porous materials until the part is completely saturated. Vacuum is maintained until the part has cured to ensure consolidation.

 

Reference

Comment

TDS

EPOVIA KRF-4500

Epoxy vinyl ester resin (marine, wind energy)

PDF

NORSODYNE I 13335 A

General purpose resin for infusion. Promoted version also available

PDF

NORSODYNE I 20282 I

General purpose resin for infusion

PDF

ENYDYNE N 50-1912 AI

Infusion resin dedicated to marine applications. Good water resistance

PDF

 

 

Title Filter     Display # 
# Article Title Author
 

Contact with us:

WE HAVE MOVED!!!!

NEW ADDRESS:

Str. Ushinskogo 40, of. 503

03151, Kiev, Ukraine

Watch on Yandex map

 

GENERAL TEL./FAX.:

+38 (044) 496-21-56

ADDITIONAL:

+38 (044) 451-73-57