|
 ENYDYNE® polyester resins are DCPD based systems with intrinsic environmental advantages and enhanced user value.
The ENYDYNE® thermosetting range includes clear, thixotropic, pre-accelerated and filled resins particularly recommended for open-mould use. ENYDYNE® resins also give excellent performance in cold press, injection moulding, and pultrusion.
Benefits for users:
- High wet-out allowing faster consolidation, further reduction in styrene emissions during consolidation, and increased filler and reinforcement loading
- Rapid increase in barcol hardness, allowing lower surface tack and faster mould turnaround
- Reduced fibre print-through
- Lower styrene emissions by up to 50%
|
Reference |
Comment |
|
PDF-file |
|
ENYDYNE E9045 |
Standard DCPD Resin |
|
PDF |
|
ENYDYNE K 00-6226 TAE |
Less than 32% styrene content. Emissions are cut by 50% compared to standard DCPD resin |
|
PDF |
|
ENYDYNE H 63380 TA |
General purpose resin – from 16 to 40 minutes gel time at 25°C, depending on catalyst nature and level |
|
PDF |
|
|
ENYDYNE H 63372 TA |
General purpose resin – from 12 to 50 minutes gel time at 25 °C, depending on catalyst nature and level |
|
PDF |
|
|
